Restorations

Mod had several definitions in my generation, but my favorite is from the ’60s and ’70s, when guys would routinely spend their weekends and pocket money taking a beloved car and making it look or perform better—mod meaning modification. These guys didn’t drive the Alphas, Porches or Vettes. They drove whatever they could afford, from VWs and MGs to Cameros, Novas, and Mustangs if they were lucky.   So, here’s a quick mod for a nickel-mount Pete to make it shine like sterling – almost. I thought of it over the holiday when I picked up my Derry Rustic, then set it down, vaguely dissatisfied.  I picked up my 2016 Elf Army and found the same mysterious disappointment. I don’t smoke pipes that don’t give me that spark of joy that marks a true pipe companion, and I thought, “Uh oh, what’s wrong?” They both smoke fine, even the acrylic f/t not being too bothersome, so what was the problem? As I held them in my hand, one after another, what I saw it as a disparity between the finish and mouthpiece on the one hand and the nickel mount on the other. Peterson’s nickel ferrules have had their ups and downs over the years. The pressed mounts, which came into use in the early 1960s, are outsourced, of course, and vary in their degree of polish by industry standards and by the era they were made. Sometimes you’ll see a System estate with a fairly polished mount, sometimes one that’s rough. The same seems to be true on new Petes. There’s different finishes and grades of nickel for varying applications, from refrigerators and toasters to automotive and medical equipment. I have no idea what grade Peterson uses, but it would be interesting to find out. The Derry Rustic Mount as Received The mounts on Derry Rustic and Elf Army I worked on for this blog are about average, neither better nor worse in their finish than previous years. That is, except for the bevel, which seems to have gone missing! The bevel is that place at the end of the cup that laps over the briar, and in years’ past it was a hallowed tradition at K&P to make sure that it was turned down to meet the wood snugly. You can tell it's there -- sort of -- in the following photo, but what there is doesn't chase around the entire cup. Peterson’s nickel mounts throughout the years are of a sufficiently high quality to take a much higher polish, albeit with the loss of a bit of the K&P over PETERSON stamping. (That stamping, by the way, goes back to their earliest registered assays marks with the Goldsmiths of Dublin, and is just about the only place you’ll see “K&P” –Kapp & Peterson – these days on a Peterson pipe.) If you’re willing to sacrifice a bit of sharpness in the stamping for a near-sterling look, go for it, I say. Back Side of the Unmodified Derry…